NVIS.DEVNIGHT VISION, UNDERSTOOD
Home / Filters & spectral control
Spectral engineering

NVIS Display Filters: IR-Cut Glass & Coatings

An NVIS filter is part of a spectral design, not a universal attachment that makes every light source compatible. The useful choice depends on source, output colors, luminance, receiver, optical geometry, and physical environment.

Compare spectral mechanisms

Begin with measurable transmission and blocking requirements. IR-cut or a single cutoff wavelength leaves the edge definition, residual transmission, and operating conditions unresolved.

Absorbing materials attenuate light within the material. Interference coatings use layered optical structures to transmit and reflect selected wavelengths. A hybrid can combine mechanisms.

ApproachDevelopment questions
Absorbing glassWhich thickness balances useful transmission, blocking, mechanical fit, and heat?
Absorbing polymerHow are optical properties, temperature, exposure, and construction controlled?
Interference coatingWhat happens across required incidence angles and polarization conditions?
Combined constructionWhat benefit justifies the interfaces, tolerances, and verification effort?

This is a comparison framework, not a ranking. Specify the assembled component rather than assuming every example within a category behaves alike.

Evaluate the source-weighted result

Filter transmission describes a fraction of incident light at each wavelength. Multiply that transmission by the actual source spectrum to estimate transmitted spectrum, while accounting for the remaining optical stack where applicable.

Small residual transmission can matter where the source emits strongly. Removing useful visible output may also require a different operating point. Assess finished luminance, color, power, thermal behavior, and applicable NVIS radiance together.

Keep curve provenance visible. Manufacturer references, calculated thickness overlays, measured prototypes, and production acceptance results are different evidence.

Thickness changes more than blocking

For a homogeneous absorbing material under the model’s assumptions, internal transmission at another thickness can be estimated from reference-thickness data:

Tᵢ(d) = Tᵢ(d₀)d/d₀

Transmission is a fraction between zero and one. This concerns internal transmission; surface reflections and coating effects need separate treatment. Results derived from reported upper bounds do not become exact measurements.

Greater thickness strengthens absorption where the material absorbs, including useful wavelengths. Brightness and color can change along with infrared rejection. Check mechanical tolerance and environmental suitability alongside the optical prediction.

Use glass grades as candidates

SCHOTT identifies BG38, BG40, BG39, and S8612 among its NIR-cut filter glasses. Their spectral behavior differs. FPD.DEV’s comparison provides reference curves and thickness/finish selections for these grades.

The question is which candidate can satisfy specified output while preserving useful light and fitting the assembly. Internal-transmission plots do not describe complete coated-component performance.

An antireflection coating addresses surface reflections. Do not assume it provides the infrared attenuation of absorbing glass or a purpose-designed spectral coating.

Close the leakage paths

A filter shapes only light that passes through it. Review source placement, joints, exposed edges, bezel gaps, reflections, and tolerances. A successful material coupon can coexist with an unsuitable assembly when light bypasses the filter.

Retain source identity, filter construction, thickness, coatings, drawing, geometry, drive conditions, and results. These details make subsequent material or supplier substitution reviewable.

Common questions

Does BG39 or S8612 guarantee NVIS compliance?

No. A glass grade provides material properties. Evidence must address the specified equipment and configuration.

Is a sharper cutoff always better?

Not necessarily. Consider the complete transmission/blocking requirement, angle range, useful colors, temperature, and assembly.

Can a CIE calculator select the filter by itself?

It supports color analysis. It cannot infer required spectral radiance evidence from chromaticity coordinates alone.

Sources & further reading

Use the current manufacturer documents and the issue of each standard specified by your program. The checklists here are engineering guidance, not quoted standard requirements.

FROM REQUIREMENTS TO A WORKING SYSTEM

Bring the optical interfaces into the conversation.

Goggles, lighting, filters, sensors, and displays need to work together. Discuss the application with FPD.DEV or introduce a customer who needs display and optical integration support.